Crushing tools for cone crushers

Crushing tools for cone crushers

The KX series of cone crushers are typically used as secondary and tertiary crushers. In this case, the material entering the crusher is crushed between the rigid crushing shell and the moving crushing cone. To achieve consistently high performance and a long service life, the entire wear surface of the crushing tool must be used. This can only be achieved if the crushing tools are selected to match the size of the material entering the crusher and the desired final product.
Crushing tools for cone crushers

Your selection: 150 Products

Reset all filters
150 Products found

Crushing shells and crushing cones

The crushing tools must achieve an optimum crushing result and a long service life, even at a high degree of utilisation. This is why different crushing tool combinations, material thicknesses and manganese steel qualities are available from KLEEMANN for varying application conditions.

Crushing shells and crushing cones
KLEEMANN MCO 9 EVO K072 1 - 9999
Standard XPERT anti-spin coarse with anti-spin
Quantity:
KLEEMANN MCO 9 EVO K072 1 - 9999
Short head XTRA anti-spin fine with anti-spin
Quantity:
KLEEMANN MCO 9 EVO K072 1 - 9999
Standard XPERT anti-spin fine with anti-spin
Quantity:
KLEEMANN MCO 9 EVO K072 1 - 9999
Short head XPERT anti-spin coarse with anti-spin
Quantity:
KLEEMANN MCO 9 EVO K072 1 - 9999
Short head XPERT anti-spin medium with anti-spin
Quantity:
KLEEMANN MCO 9 EVO K072 1 - 9999
Short head XPERT anti-spin fine with anti-spin
Quantity:
KLEEMANN MCO 9 EVO K072 1 - 9999
Standard XPERT coarse without anti-spin
Quantity:
KLEEMANN MCO 9 EVO K072 1 - 9999
Standard XPERT medium without anti-spin
Quantity:
KLEEMANN MCO 9 EVO K072 1 - 9999
Standard XPERT fine without anti-spin
Quantity:
KLEEMANN MCO 9 EVO K072 1 - 9999
Short head XPERT coarse without anti-spin
Quantity:

Due to possible technical changes, always refer to the information in the instruction manual.